PANAVISION Genesis, User Manual

Page: 214 / 278

Panavision Genesis Manual v1.3
–
214
V39
You must turn 2 POWER switches ON to operate the VTR:
- POWER on the SRW-1 connector panel
- POWER on the SRPC connector panel
You can turn both units off using the POWER switch on the SRPC
Panavision recommends you leave EXT DC SELECT on AUTO. The
EXT positions forces the SRPC to always use power from the DC IN,
even when this voltage is low or off.
21.5 Use 2 BNC cables
You can record the Genesis on a separate VTR using 1 or 2 BNC
cables. Because of the increased data flow, you need the 2 cable
configuration to record “Dual Link” HD SDI 444 or to record 422 at
S59.94 or S60. With one cable you can only record 422 from the HD
SDI output of the Genesis.
Panavision strongly recommends that you record 444 when the
SRW-1 is separated from the Genesis. This entails a “Dual link” HD-
SDI connection using 2 BNC cables
Be sure to use CBLE-BNCH Canare cables or equivalent.
Do not run lengths of more than 75 feet without an in-line amplifier.