21
8 Settings and Operations
8.1 Power (ON) / (OFF)
Note:
· When a generator is used, please be sure to
turn off power switch of the Machine before
starting up generator.
· Regarding the cooling fan
-after turning on the power switch, the fan starts
rotate
-if stand-by status lasts over 7 minutes, the fan
stop rotating and machine runs into the
power-saving mode.
-when the cooling fan stops, press the cutting
torch switch the fan rotates again.
8.2 Initial display
When the power is turned on, initial information is
displayed as follows:
(1) Every LED lights up for LED testing and goes
out in the order of
,
,
,
,
.
① ② ③ ④ ⑤
(2) The following product information is displayed
on the digital display.
(2-1) DPS number (Software ID Number)
(2-2) Version number
< Note >
·If any error occurs at the time of startup, digital
display shows "E" and error number. For the
description of the error number, please refer to
【
13.1 Error numbers and descriptions
】
.
·These numbers act as examples. There may
some differences with actual displayed numbers.
(3) After the version number is displayed and
every LED goes off, the machine runs into
stand-by mode and the previously set cutting
current settings is displayed.
The default setting is rated output current value.
Front
Power switch
1
2
5
3
4
