36
Configure the settings relating to the host authentication [Host]
Click the [Host] tab on the "Authentication setup" page. (
☞
page 35)
The settings to restrict PCs (IP address) to access the camera can be configured on this page.
[Host authentication]
Select ON or OFF to determine whether or not to
authenticate the host.
Default:
OFF
Important:
Before configuring the host authentication, it is nec-
essary to register IP addresses of the PCs to be
allowed to access the camera and determine their
access levels. If "ON" is selected for "Host authenti-
cation" before registering the hosts (IP addresses), it
will be impossible to access the camera.
[IP Address]
Enter the IP address of the PC to be allowed to access
the camera.
Notes:
•
When "IP address/subnet mask" is entered, it is pos-
sible to restrict PCs in each subnet.
•
When the IP address already in use is entered and
the [REG] button is clicked, the respective host infor-
mation will be overwritten.
[Access level]
Select the access level of the host from the following.
1. Administrator/2. Camera control/3. Live only
Refer to page 35 for further information about the
access level.
Default:
3. Live only
Note:
By clicking [
i
] of "Host check", the registered host
can be selected and the selected host
’
s IP address
can be checked.
The registered IP address will be displayed with the
access level. (Example: 192.168.0.21 [1])
To delete the registered host, click the [DEL] button
after selecting the IP address to be deleted.
