47
■
Controller Setup
Set up the baud rate and parity check mode for the controller while observing the LED on the front panel.
●
Administrator Authorization
1. Press the CAM/SET button while [SEtUP] is displayed.
The [- - - - -] prompt appears.
2. Enter a password with the numeric buttons, then press
the CAM/SET button.
The default setting is [12345].
3. If the password entered is valid, [SPEED] appears. If
password entry failed, the menu returns to [SEtUP].
●
Baud Rate
In this menu, the communication speed (bps: bits per sec-
ond) is selected. The communication speed should match
that of the WJ-FS616/FS616C.
1. Display [SPEED] and press the CAM/SET button twice.
2. Select a parameter entering a bracket-enclosed num-
ber, e.g., (3), moving the joystick to right and left, or
pressing the [+] and [–] buttons.
The default setting is 9 600 bps.
(1) 2 400:
2 400 bps
(2) 4 800:
4 800 bps
(3) 9 600:
9 600 bps
(4) 19 200:
19 200 bps
Note:
Selecting a slower rate (e.g., 2 400 bps) will delay
the response time (e.g., the time until an activated
alarm is reset).
3. Press the
CAM/SET
button to validate the selection.
4. Press the
ESC
button to go back to the previous menu.
●
Parity
In this menu the parity check mode is selected.
1. Display [PrtY] and press the
CAM/SET
button twice.
2. Select a parameter with the joystick.
The default setting is None.
n:
None
E:
Even parity
3. Press the
CAM/SET
button to validate the selection.
Menu
Selection
Move Joystick
UP and down
to select
Setup Menus
Parameter Selection (default*)
LED Display
blinking
Setup
Administrator
Password
Prompt
Speed
Parity
Initial
Display
Authorization
Baud Rate
(bps)
Press
twice
Parity Check
CAM
SET
CAM
SET
MON
ESC
LED prompts you to enter pass-
word
Enter a 5-digit password,
press (12345*)
(1) 2 400 (2) 4 800 (3) 9 600*
(4) 19 200
(1) None* (2) Even
Reading
Function
OK
No
DOWN
L
R
UP
L
R
CAM
SET
