62
7.6 Event
7.6.1.
Video Detection
7.6.1.1 VMD
The [VMD] interface is shown as in Figure 7-47.
Figure 7-47
Refer to the following sheet for detailed information.
Parameter
Function
Enable
You need to check the box to enable VMD function.
Working Period
Here you can set arm/disarm period. Click on the [Set] button to open period setup
menu.
There are six periods every day for setup and you must check box in front of each
period to enable it.
Note: Period setup can be done by dragging mouse while not release left mouse.
Anti-Dither
System only memorizes one event during the anti-dither period. The value ranges
from 0s to 100s.
VMD area
Here you can set motion detection region and its sensitivity and area. (The higher
the sensitivity is, the easier to trigger motion detect; the smaller the area, the
easier to trigger motion detect.) The default covers all regions. You must click on
the [Save] button before enabling your setup.
Record
Check it and so when VMD occurs, system will auto record. You shall set record
period in Storage>Schedule and select auto record in record control interface.
Record Delay
System can delay the record for specified time after alarm ended. The value
ranges from 10s to 300s.
Relay out
Enable alarm activation function. You need to select alarm output port so that
system can activate corresponding alarm device when alarm occurs.
Alarm Delay
System can delay the alarm output for specified time after alarm ended.
The value ranges from 10s to 300s.
Send Email
If you enabled this function, System can send out email to alert you when alarm
occurs and ends.
