Panasonic WV-SF448, Operating Instructions Manual

Page: 135 / 228

•
Default: Off
[Image quality upon alarm detection]
Image quality can be changed upon an alarm occurrence. Select the image quality from the following.
0 Super fine/ 1 Fine/ 2/ 3/ 4/ 5 Normal/ 6/ 7/ 8/ 9 Low
•
Default: 5 Normal
Note
•
When privacy mode is active, black images will be transmitted.
13.4 Configure the settings relating to H.264
recording [Alarm]
Click the [Alarm] tab on the “Alarm” page. (
®
page 55, page 57)
The settings relating to the recording H.264 data on the SD memory card when an alarm is detected can be
configured on this page. To operate recording, it is necessary to configure the settings relating to SD memory
card and the video data. (
®
page 65)
IMPORTANT
•
When “VGA Quad streams [4:3]” is selected for “Image capture mode”, “H.264 recording(SD memory
card)” is unavailable.
H.264 recording (SD memory card)
[Pre alarm]
Determine whether or not to perform the pre alarm recording. When “Use” is selected, approx. 1 MB image
data is always saved during the pre alarm recording.
Use/ Not use
•
Default: Not use
[Post alarm (recording) duration]
Set the duration to save image data on the SD memory card after an alarm occurrence.
10s/ 20s/ 30s/ 40s/ 50s/ 60s/ 120s/ 180s/ 240s/ 300s
•
Default: 30s
* The actual recording time may sometimes be longer than the duration selected for this setting.
[Recording (memory) size per an alarm]
The capacity of the SD memory card used to record video data upon an alarm occurrence. The actual capacity
may be different.
IMPORTANT
•
To record H.264 data, it is required to select “Use” for “SD memory card” on the [SD memory card] tab.
In addition, it is required to select “H.264(1)” or “H.264(2)” for “Recording format”. (
®
page 65)
Operating Instructions 135
13 Configure the alarm settings [Alarm]