- 31 -
1. Remove the mounting screw (M3) from the
camera mounting angle (provided).
2. Mark the mounting holes on the ceiling, using
the removed camera mounting angle as a
template.
Marking
3. Fix the camera mounting angle to the ceiling
with four screws (not provided).
Caution:
The installation should be strong enough
to support 4 times the total weight.
Note:
Be sure to protect the video and power
cables. Otherwise, the cut edges will
damage the cables.
Diecast Case
3. Assemble the camera
Reverse the disassembly procedure. Take
care not to cut any cables.
Precautions:
1. The following installation work should be
referred to qualified service personnel or
system installers and must conform with local
codes.
2. Be sure to select a ceiling board that is strong
enough to support this camera.
3. To mount the camera on any other kind of
ceiling, use the optional ceiling bracket WV-
Q105, WV-Q106 or WV-Q107.
4. To mount the camera on the wall, use the
optional wall mount bracket WV-Q108.
a. Sideway cable exit
Prepare a cutout in the diecast case and
decoration cover as shown in the following
drawing.
PAL (CCIR) or
NTSC (EIA)
DIP
φ
OFF
NTSC (EIA)
ON
PAL (CCIR)
Note:
The dip switch
φ
is not for changing NTSC
(EIA) to PAL (CCIR) or PAL (CCIR) to NTSC
(EIA). This switch is set at factory. Do not
change the setting of this switch. The factory
setting is ON.
b. Top cable exit
Summary of Contents for WV-BS500
Page 3: ......
