- 27 -
11. Auto Focus Setting (AF MODE)
1. Move the cursor to AF MODE, and move the joystick to the left or
right to set auto focus operation mode.
MANUAL:
The AF mode is activated by pressing the AF button of the
controller.
AUTO:
AF mode is activated automatically after a manual panning,
tilting or zooming operation.
Note:
AUTO in AF MODE is disabled unless SENS UP is set to OFF.
If SENS UP is not OFF, AF MODE is set automatically to
MANUAL.
2. To set an area
Move the cursor to MANUAL or AUTO, and press the CAM (SET) key.
The AF AREA SET menu is shown. Move the cursor to AREA, and
move the joystick to the left or right to select LARGE, MID or SMALL
for the area.
3. To confirm operation
To check auto focus operation, move the cursor to AF CHECK, and
press the CAM (SET) key.
Notes:
• When the electronic sensitivity enhancement (SENS UP) is active, this
function is automatically set to MANUAL.
• The auto focus lens may not function properly in AUTO under the
following conditions.
1. Dirt or water on window glass.
The auto focus may focus on the dirt or water.
2. Low lighting/illumination or zone marker is blinking.
3. Bright objects or high intensity objects.
4. Single colour with unfigured object such as white wall or fine felt.
5. No centre objects, sloping objects.
6. Far and near objects on the screen.
Important Notice:
• The object of motion detection should meet the following conditions.
1) It should be larger than 1/48 of the size of the picture screen.
2) The contrast ratio (at max. detection level) between the object
and the background picture on the screen should be more than
5%.
3) The time it takes the object to move from one end of the screen to
the other should be more than 0.1 seconds.
• Also under the following conditions, mask or adjust the detection level
to prevent malfunction.
1) When leaves or curtains etc, are swayed by the wind.
2) When a noisy picture exists such as under low light condition.
3) When the object is subjected to illumination by lighting
equipment that constantly turns on and off.
• The alarm signal will take about 0.2 second to reach the alarm
terminal of the VTR, after the camera detects the object.
Because the alarm signal is multiplexed on the video signal it may be
mistakenly interpreted by other video equipment as a time code
signal. Therefore, when this camera is not used in a Panasonic
Intelligent CCVE System, select OFF to prevent the above from
occurring.
** SET UP **
CAMERA ID OFF *
ALC/MANUAL ALC *
SHUTTER OFF
AGC ON
SENS UP OFF
SYNC INT
WHITE BAL ATW *
WIDE D-RANGE OFF
MOTION DET OFF
AF MODE MANUAL *
RET SPECIAL *
Camera setting menu
** AF AREA SET **
AREA MID
AF CHECK
→
PUSH SW
RET
** AF AREA SET **
AREA MID
AF CHECK
→
PUSH SW
RET
Area setting menu
Summary of Contents for WV-BS500
Page 3: ......
