Panasonic Workio DP-C405, Service Handbook

Page: 439 / 808

439
DP-C405/C305/C265
FEB 2008 Ver. 1.1
010 TX Level 00 = 0 dBm
~
-15 = -15 dBm Selects the TX signal output level, 0 to -15 dBm in 1
dBm steps. (Refer to Chapter 3.3.)
011 RX Level -43 dBm
-38 dBm
-33 dBm
-48 dBm Selects the receiving sensitivity of -33/-38/-43/-48
dBm.
012 DTMF Level 00 = 0 dBm
~
-15 = -15 dBm Selects the DTMF output level, 0 to -15 dBm in 1
dBm steps.
013 G3 RX EQL 0dB
4dB
8dB
12dB Selects the cable equalizer for G3 reception mode,
0dB, 4dB, 8dB or 12dB.
014 G3 TX EQL 0dB
4dB
8dB
12dB Selects the cable equalizer for G3 transmission
mode, 0dB, 4dB, 8dB or 12dB.
015~
016
Not Used
017 TX Start 2400 bps
4800 bps
7200 bps
9600 bps
TC7200
TC9600
12000 bps
14400 bps Selects the transmission modem start speed, 14400/
12000/TC9600/TC7200/9600/7200/4800/2400 bps.
Note:
This parameter is applicable only when
communicating with regular G3 machines. When
communicating with Super G3 (V.34) machines,
use Parameter No. 32.
018 RX Start 2400 bps
4800 bps
7200 bps
9600 bps
TC7200
TC9600
12000 bps
14400 bps Selects the reception modem start speed, 14400/
12000/TC9600/TC7200/9600/7200/4800/2400 bps.
Note:
This parameter is applicable only when
communicating with regular G3 machines. When
communicating with Super G3 (V.34) machines,
use Parameter No. 33.
019 ITU-T V.34 Off
On
Select Selects whether the ITU-T V.34 is Off, On or Select.
Select : Select whether the ITU-T V.34 is Off or On,
when entering Phone Book Dialing Numbers
or Manual Number Dialing.
020 ITU-T ECM Off (Invalid)
On (Valid) Select the ECM mode.
021 EP Tone Off (without EP Tone)
On (with EP Tone) Selects whether to add the echo protect tone on V.29
mode.
(Used when Echo Suppression is disabled.)
On : Add
Off : Do not add
022 Signal Interval 100 ms
200 ms
500 ms Selects the time interval between the receiving
signal, and the transmitting signal.
023 TCF Check Normal (Short)
Long Selects the TCF check interval Long/Short
Function Parameter Table
No. Parameter Selections Function