Panasonic WJ-CU550A, Operating Instructions Manual

Page: 54 / 138

-50-
4
INSTALLATION
The installation described below should be made by quali-
fied service personnel or system installers.
■
WV-CU550A System Controller
Replacing the Side Panels with the optional
WV-Q62E Rack Angle Bracket
1. Remove both the left and right side panels of the
System Controller by removing four screws.
■
WJ-SX550A Matrix Switcher
Mounting into the Rack
1. Remove four rubber feet by removing four screws on
the bottom of the Matrix Switcher.
2. Remove the Palm-rest located on the front of the
System Controller by removing two screws.
3. Place the Rack Angle Brackets on both sides of the
System Controller and tighten with the four supplied
screws.
4. Install the System Controller with Rack Angle Brackets
in the rack by using four screws (procured locally).
Remove screws.
Tighten
screws.
Rack Angle Bracket
Side Panel
Rack Mount Screws
Rack Mount Screws
Palm-rest
• Do not block the ventilation opening or slots on the cover to prevent the unit from rising temperature.
Always keep the temperature in the rack within 50°C (122°F)
• Secure the rear of the unit to the rack by using the additional mounting angles (procured locally) when the vibration is
added to the rack.
Caution
2. Install the Matrix Switcher in the rack by using eight
screws (procured locally).
Note:
The cooling fans inside the Matrix Switcher are
article of consumption, and need to replace peri-
odically.
Remove Screws
Rubber
feet
Rack Mount Screws
Rubber
feet