Panasonic WJ-CU550A, Operating Instructions Manual, Page: 16 / 138

-13-
1. Log-in
To operate the Matrix Switcher System 500, a registered
operator must first supply their Operator Number and
Password to the system controller.
The operator number and password are established by
using the Set Up Menu. See page 83 for more details on
operator number registration.
If an attempt is made to enter an operator number and
password that do not match with the registered operator
numbers and passwords, entry into this system is denied.
As shown in the examples below, there are 2 additional
attributes associated with an operator: operator level and
priority. These items are described in more detail on page
19.
Operator Name: Mike
Operator Number: 01
Operator Level: 01
Password: 07171
Priority: 1
Operator Name: Robert
Operator Number: 30
Operator Level: 05
Password: 11524
Priority: 30
Notes:
1. Initially, Operator Number: 1
Password:
12345
are registered at the factory to allow access for first
time system programming.
2. An operator can be logged-in to this system from sev-
eral system controllers.
3. If the main power of the Matrix Switcher is turned off,
log-in procedures must be performed again.
4. If power to the system controller is turned off, the sys-
tem controller will record operating status when power
is resupplied.
2. Camera and Monitor Selection
After log-in, the desired camera and monitor combination
can be selected.
Basically, any combination of camera and monitor, which
are connected to this unit, can be selected as shown
below.
1 2
3
General Procedures
1. Select the desired monitor. (monitor and controller are
linked.)
2. Select the desired camera (camera and controller are
linked.)
3. The picture of the selected camera is displayed on the
selected monitor.
2-1 Monitor Selection
By selecting the monitor with the System Controller, it is
linked with the System Controller.
At this time, the camera output signal that was last sup-
plied to the monitor is displayed.
Press the Numeric keys (1 to 16) then press the MON key
to select the desired monitor.
CAM
ESC SET
1 2 3
4 5 6
7 8 9
MON
0
For example: When selecting monitor No. 5:
Press 5 then press MON key.
Camera-1 Camera-2
Monitor-1 Monitor-2
WJ-SX550A
Controller
WV-RC150
2