Panasonic WH-MDF09C3E8, Service Manual

Page: 46 / 129

46
6 Insert firmly the connector of remote control
cable (2) to connector (CON1) in the upper
case circuit board. (Refer to the illustration at
below)
7 Secure the remote control upper case to the
lower case with the tabs provided.
11.4.3.3 Connecting The Remote Control
Cable To Mono Bloc Unit
WARNING
Be sure to turn off the main power before installing and connecting
the remote control. Otherwise, it will cause the electrical shock.
1. Remove the cabinet front plate.
2. Connect the remote control cable with the provided
connector as shown in below illustration. (Refer wiring
diagram for detail.)
3. Guide the remote control cable through the clamper
and Bushing .
(Refer illustration “How to connect Remote Control to
Provided Connector” for detail.)
4. Reinstall the cabinet front plate after connection
complete.
11.4.3.4 Disposal of Mono Bloc Unit
Drain Water
š
When a Drain elbow is used, please ensure to follow
below:
o
The unit should be placed on a stand which is taller
than 50mm.
o
Cover the 8 holes (ø20mm) with Rubber cap (refer
to illustration below)
o
Use a tray (field supply) when necessary to dispose
the Mono bloc unit drain water.
š
If the unit is used in an area where temperature falls
below 0°C for 2 or 3 consecutive days, it is recommended
not to use the Drain elbow and Rubber cap , for the
drain water freezes and the fan will not rotate.