Panasonic WH-MDF09C3E8, Service Manual

Page: 42 / 129

42
11.4 Connect The Cord And Cable To Mono Bloc Unit
(REFER TO WIRING DIAGRAM AT UNIT FOR DETAIL)
1. An isolating device must be connected to the power supply cable (Disconnecting means).
š
Isolating device (Disconnecting means) should have minimum 3.0 mm contact gap.
š
Connect the approved polychloroprene sheathed power supply 1 cord (5 x min 1.5 mm
2
) and power supply 2
cord (3 x min 1.5 mm
2
) and power supply 3 cord (5 x min 1.5 mm
2
), type designation 60245 IEC 57 or heavier
cord to the RCCB, and to the other end of the cord to isolating device (Disconnecting means).
2. To avoid the cable and cord being damaged by sharp edges, the cable and cord must be passed through a
bushing (located at the right hand side of the mono bloc unit) before being connected to the terminal block. The
bushing must be used and must not be removed.
3. Secure the cable onto the control board with the holder (clamper).