Panasonic UF 8200 - Panafax - Multifunction, Service Manual

Page: 136 / 261

136
UF-7300/7200
UF-8300/8200
401 XMT B DCN was returned from receiver
while transmitter is waiting for CFR or
FTT. Your machine's ID Number is not
programmed.
Possible incompatibility or incorrect
Password.
402 XMT B DCN was returned from receiver
while transmitter is waiting for NSF/
DIS. Receiver working in non-ITU mode
only. (Possible incompatibility)
403 RCV
(Polling)
B Transmitter had no polling function. "POLLED=ON" (polling XMT ready) is
not set at the transmitter.
Document to be transmitted is not
placed at the transmitter.
404 XMT B Transmitter sent NSS (or DCS)
followed by TCF three times, but the
receiver did not respond. (CFR or
FTT is usually returned) Receiver is defective. (Modem)
SC PCB or FXB PCB is defective.
Receiver disconnects line during first
NSS (or DCS) is transmitted.
405 XMT B Transmitter received FTT after it
transmitted TCF at 2400bps.
Received RTN after communicating
at 2400 bps. Line quality is poor. (TCF is damaged
due to line noise)
Receiver is defective. (Modem, etc.)
SC PCB or FXB PCB is defective.
406 RCV
(Password
Comm.)
B XMT-Password mismatched.
RCV-Password mismatched.
Selective RCV incomplete. XMT, RCV password does not match.
Last 4 digits of TSI does not match with
the last 4 digits of ONE-TOUCH, ABBR
telephone number.
407 XMT D Transmitter received no response
after it transmitted post message,
such as EOP, MPS, EOM, etc...or
received DCN. Receiver is defective. (No paper, paper
jamming, etc.)
Receiver ceased receiving because of
excessive error. (Line quality is poor)
SC PCB or FXB PCB is defective.
408 XMT D Transmitter received RTN after it
transmitted EOP, MPS, or EOM. Receiver receives data with error. (Line
quality is poor)
Receiver is defective. (Modem, etc.)
SC PCB or FXB PCB is defective.
409 XMT D Transmitter receives PIN after it
transmitted a post message, such as
EOP, MPS, EOM, etc. Receiver receives data with error due to
poor line quality, and receiving operator
requests voice contact.
Receiver is defective. (Modem, etc.)
SC PCB or FXB PCB is defective.
410 RCV D Received DCN while waiting for post
command. (EOP, MPS, EOM, etc.) Interface or line is faulty.
Transmitter is defective.
411 RCV
(Polling)
B Received DCN after transmitting
NSC. Transmitter is not ready for polling
communication.
Password does not match between
transmitter and receiver.
412 G3 RX B, D No response within 12 seconds in
NSS/DCS/MPS wait state. (After
transmitting FTT)
Transmitter is defective.
SC PCB is defective.
414 RCV
(Polling)
B No response received after
transmitting 3rd NSC. Password does not match between
transmitter and receiver.
Transmitter is defective. (No original,
document jam, etc.)
415 XMT
(Polling)
B Remote side attempted to receive
message from your machine in polling
communication. Inform the remote side that your
machine does not have the polling
transmission feature.
Fax Information Codes
Code Mode Phase Description of Problem Cause