RQTV0311
27
REAL CENTER
function
Makes the dialogue
from the center
speaker clearer when
playing surround
sources.
Factory setting is
“ON”
. See right to set it
“OFF”
.
Test signal is output from one speaker at a time for two seconds in the following
order.
•
You cannot adjust the front speaker level with this process.
The test signal comes from the speaker being adjusted.
Test signal is output again in above order 2 seconds after adjustment.
•
•
•
2
1
Press
.
Press
to adjust front
speakers’ normal listening volume.
3
Press
or
to adjust
each speaker’s output level.
L
(Front left)
→
C
(Center)
→
R
(Front right)
→
SUBW
(Subwoofer)
Speaker
Adjusting speaker
output
Adjust the output
of each speaker to
balance with front
speakers according
to the seating area.
Adjustment range:
OFF, MIN, 1 to 19, MAX
Adjustment range:
–10 to +10
Factory setting:
0
4
Press
to stop test signal.
The effect changes as soon as you select
“ON”
or
“OFF”
but you must press [OK] to
confirm selection.
•
Only appears when audio adjustment can be made.
Reducing
standby power
consumption
(Standby mode)
HDMI standby
(
page 14) does
not work in this
mode if you have
connected through
the HDMI terminal.
VIERA Link
(
pages 24 and
25) will not function
when this unit is off.
2
1
Press
to select
“HDMI”
.
3
Press
to select
“STNBY”
.
STNBY, CTRL
5
Press
a few times to select
“EXIT”
.
Press
OFF : Standby power consumption reduced
(approximately 0.4 W)
ON: Normal standby power consumption
4
Press
to select
“OFF”
.
Factory setting:
ON
1
Press
to
confirm.
Select
“EXIT”
and
confirm to finish the
setup mode.
•
Press and hold
for about 2 seconds.
3
Press
to select
“OFF”
.
ON, OFF
Factory setting:
ON
4
Press
a few times to select
“EXIT”
.
Return to previous menu/cancel.
•
Press
2
Press
to select
“REAL C.”
.
REAL C.,
BASS,
TREBLE, SLEEP, HDMI,
TV DELAY, DRCOMP, ATTENUATOR, REMOTE,
INPUT MODE, RESET, EXIT
Press
to
confirm.
Press
to
confirm.
Press and hold
for about 2 seconds.
REAL C.,
BASS,
TREBLE, SLEEP, HDMI,
TV DELAY, DRCOMP, ATTENUATOR, REMOTE,
INPUT MODE, RESET, EXIT
Return to previous menu/cancel.
•
Select
“EXIT”
and
confirm to finish the
setup mode.
•
Press
to
confirm.
Press
to
confirm.
Press
to
confirm.
Press
to
confirm.
Play
Functions and settings
Functions and settings
SC-HTR200 (RQTV0311-2B)_En_GMK_with ferrite core.indd 27
2/14/2008 11:56:55 AM
