-
Stops during a performance.
The function of this circuitry is to prevent circuitry damage if, for example, the
positive and negative speaker connection wires are “shorted”, or if speaker
systems with an impedance less than the indicated rated impedance of the
amplifier are used.
If this occurs, follow the procedure outlines below:
1. Turn off the power.
2. Determine the cause of the problem and correct it.
3. Turn on the power once again after one minute.
Note:
When the protection circuitry functions, the unit will not operate unless the power
is first turned off and then on again.
3. Accessories
AC power cord
Battery Service Life
UM-1 (D-size) Batteries
Approximately 28 hrs of Tape Recording. (EIAJ)
Approximately 14 hrs of Tape Playback. (EIAJ)
Approximately 10.5 hrs of CD Recording. (EIAJ)
4
Summary of Contents for RXD10 - RADIO CASSETTE W/CD
