Chapter 4
Settings — [DISPLAY OPTION] menu
110 - ENGLISH
5) Press
as
to select the combination of the DVI-D input and HDMI input and press the <ENTER>
button.
6) Press the <MENU> button.
f
The
[BACKUP INPUT SETTING]
screen is displayed.
7) Press
as
to select [AUTOMATIC SWITCHING].
f
[AUTOMATIC SWITCHING] cannot be selected when [BACKUP INPUT MODE] is set to [OFF].
8) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[ENABLE]
Switches to the secondary input automatically when the input signal for primary input is disrupted.
[DISABLE]
Disables the automatic input switching function.
Note
f
The backup function is enabled when [BACKUP INPUT MODE] is set to anything other than [OFF] and same signal is input to the primary
input and the secondary input.
f
To switch to the backup input signal using the backup function, make sure that the following three conditions are satisfied to be ready to use
the function.
g
Set [BACKUP INPUT MODE] to a combination of the DVI-D input and HDMI input.
g
Input the same signal to the primary and secondary inputs.
g
Display the image of the primary input.
f
In the following cases, the state of readiness is canceled. To switch to the backup input signal using the backup function, switch to the
primary input and enter the state of readiness.
g
When switching to an input other than the primary input from the state of readiness
g
When switching to the secondary input while the backup function is active
f
When [BACKUP INPUT MODE] is set to anything other than [OFF], the combination of that input is displayed in [PRIMARY INPUT] and
[SECONDARY INPUT] of the
[BACKUP INPUT SETTING]
screen.
f
[BACKUP INPUT STATUS] is displayed in the input guide (
x
page 117) and the
[STATUS]
screen (
x
pages 75, 143) when [BACKUP
INPUT MODE] is set to anything other than [OFF].
When the signal can be switched to the backup input signal using the backup function, [ACTIVE] is displayed in [BACKUP INPUT STATUS].
When it is not possible, [INACTIVE] is displayed instead.
f
When [AUTOMATIC SWITCHING] is set to [ENABLE], and [BACKUP INPUT STATUS] shows [ACTIVE], the signal is switched to the
backup input if a disruption occurs in the input signal.
f
The primary input setting values are applied to image adjustment values such as the [PICTURE] menu
→
[PICTURE MODE], [GAMMA],
and [COLOR TEMPERATURE].
[RGB IN]
Set the <RGB 1 IN> terminal and the <RGB 2 IN> terminal.
Switching the slice level of an input synchronization signal
1) Press
as
to select [RGB IN].
2) Press the <ENTER> button.
f
The
[RGB IN]
screen is displayed.
3) Press
as
to select [RGB1 SYNC SLICE LEVEL] or [RGB2 SYNC SLICE LEVEL].
4) Press
qw
to switch the item.
[LOW]
Set the slice level to [LOW].
[HIGH]
Set the slice level to [HIGH].
Setting [RGB2 EDID MODE]
1) Press
as
to select [RGB IN].
2) Press the <ENTER> button.
f
The
[RGB IN]
screen is displayed.
3) Press
as
to select [RGB2 EDID MODE].
4) Press the <ENTER> button.
f
The
[RGB2 EDID MODE]
screen is displayed.
