Panasonic PT-RW630 series, Operating Instructions Manual

Page: 117 / 185

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 117
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[NORMAL] Select this item to use the network function during standby.
[ECO] Select this item to reduce power consumption during standby.
Note
f
When [ECO] is set, the network function, the <SERIAL OUT> terminal, and some RS-232C commands become inoperable during standby.
In the [NORMAL] setting, the network function and the <SERIAL OUT> terminal become operable during standby.
f
When [ECO] is set, it may take approximately 10 seconds longer before the projector starts projecting after the power is turned on,
compared with when [NORMAL] is set.
f
The [STANDBY MODE] settings are not reset to the factory defaults even when [ALL USER DATA] is executed from the [PROJECTOR
SETUP] menu → [INITIALIZE] (
x
page 124).
[SCHEDULE]
Set the command execution schedule for each day of the week.
Enabling/disabling the schedule function
1) Press
as
to select [SCHEDULE].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[OFF] Disables the schedule function.
[ON]
Enables the schedule function. Refer to “How to assign a program” (
x
page 117) or “How to set a
program” (
x
page 117) for how to set the schedule.
Note
f
When [SCHEDULE] is set to [ON], the [STANDBY MODE] setting is forcibly switched to [NORMAL], and the setting cannot be changed.
Even if [SCHEDULE] is then set to [OFF] when in this state, the setting of [STANDBY MODE] remains at [NORMAL].
How to assign a program
1) Press
as
to select [SCHEDULE].
2) Press
qw
to select [ON], and press the <ENTER> button.
f
The [SCHEDULE] screen is displayed.
3) Select and assign program to each day of week.
f
Press
as
to select the day of week, and press
qw
to select a program number.
f
You can set the program from No.1 to No.7. “- - -” indicates that the program number has not been set.
How to set a program
Set up to 16 commands to each program.
1) Press
as
to select [SCHEDULE].
2) Press
qw
to select [ON], and press the <ENTER> button.
f
The [SCHEDULE] screen is displayed.
3) Press
as
to select [PROGRAM EDIT].
4) Press
qw
to select a program number, and press the <ENTER> button.
5) Press
as
to select a command number, and press the <ENTER> button.
f
You can change the page using
qw
.
6) Press
asqw
to select [TIME], and press the <ENTER> button.
f
The projector is in the adjustment mode (where the time is blinking).
7) Press
qw
to select “hour” or “minute”, and press
as
or the number (<0> - <9>) buttons to set a
time, and then press the <ENTER> button.
8) Press
asqw
to select [COMMAND].