24
1
WIND-CUT
M ENU
1
Quick Start
When this feature is activated, you can resume recording quickly even if the
Palmcorder goes into standby mode (when left in Pause mode for 5 minutes).
Palmcorder will be ready for shooting in approximately 1.5 seconds when the
Power switch is turned [OFF] and back to [ON] again. To activate this feature,
press the [QUICK START] button to turn on the Quick Start Lamp.
However, this feature will not work under the following conditions even if the
Quick Start Recording Lamp is on:
≥
If there is no tape inserted while Palmcorder is set to Tape mode.
≥
If there is no card inserted while Palmcorder is set to Card mode.
If the [QUICK START] Button is pressed and held for approximately
2 seconds while the Quick Start Lamp is on, the lamp will go off and the
power will completely be turned off.
Also, if the Palmcorder is not operated for approximately 30 minutes while the
Quick Start Recording Lamp is on, the lamp will go off and the power will
completely be turned off.
If the battery is replaced while in the Quick Start mode, the Quick Start mode
is retained.
During the Automatic White Balance Mode, the color may be recorded
unnaturally at the beginning of the recording.
The zoom magnification differs from when it is in the Recording Pause mode
and when the recording starts.
~~~~~~~~~~~~~~~~~~~~~~~~
Wind Noise Reduction Function
This function reduces the noise that the wind makes as it hits the microphone
during recording.
1
Set [CAMERA FUNCTIONS] >> [RECORDING SETUP] >>
[WIND-CUT] >> [ON].
≥
The [WIND-CUT] Indication
1
appears.
~~~~~~~~~~~~~~~~~~~~~~~~
Recording in Special Situations
(Program AE)
Select optimal automatic exposures under specific recording situations.
1
Set the Mode Selector Switch to [MANUAL].
≥
The [MNL] Indication appears.
2
Set [CAMERA FUNCTIONS] >> [CAMERA SETUP] >>
[PROG.AE] >> a desired Mode [
5
], [
7
], [
4
], [
Ω
], [
º
].
≥
The Indication of the selected Mode is displayed.
[
5
] Sports Mode
1
For Recording scenes involving quick movements, such as sports scenes.
[
7
] Portrait Mode
2
Focuses on the main subject of the image and leaves the background slightly
out of focus.
[
4
] Low Light Mode
3
Preserves the mood of dim light settings without altering picture brightness.
[
Ω
] Spotlight Mode
4
Neutralizes the additional brightness created by a spotlight.
[
º
] Surf & Snow Mode
5
Compensates for excessive illumination from sun glare to produce a clear
picture.
Canceling the Program AE Function
Set [PROG.AE] on the [CAMERA SETUP] Sub-Menu to [OFF]. Or, set the
Mode Selector Switch to [AUTO].
≥
For other notes, see page 57.
1
3
2
4
5
1
M ENU
2
AUT
O
MANU
AL
FOCUS
START
QUICK
