Washing Instructions - 17
Washing
CAUTION
After a high temperature wash, be
careful not to burn yourself when
handling the laundry or touching
the inside of the drum.
Note
-If the detergent is not completely
removed from the laundry by using
the basic programme, use the Extra
Rinse function.
-With the Eco and the Speed
functions, if the load is big, the
laundry may stick to the inside of the
drum. This is normal.
- Remove the laundry and rearrange
where necessary. Do not leave it in the
drum too long after the programme ends
to prevent colour transfer.
Required time
Required time depends on the programme
and temperature setting.
- Actual time may differ slightly from the
displayed time.
- The displayed time includes the time
needed for the water to fill up and to
drain out, thus they vary depending on
water pressure, drainage and amount of
laundry.
- If you change the function setting
while washing, the displayed time may
change.
- If the laundry in the drum needs to be
balanced, the time will be extended.
Setting the buzzer
The buzzer that sounds when a
programme finishes can be turned off.
1. Press the Start and On buttons at the
same time.
2. Release the On button and keep
pressing the Start button for
3 seconds. The buzzer setting will be
turned off after a beep is heard.
If you wish to reset the setting, perform
the same steps 1 and 2. The buzzer
setting will be turned on after two beeps
are heard.
Changing settings while
washing
After washing has started, the programme,
temperature and preset time cannot be
changed.
-To change the programme or temperature
setting, turn the appliance off and then on
again.
-To change the rinse or spin setting while
washing, press the Pause button once
the appliance is full of water.
-You can change the Spin speed, Extra
Rinse and Easy Ironing function during
the washing process.
-No settings can be changed after the
washing process has finished.
NA-140_168_148VS4_WGB_En.indb 17
2013/11/06 19:06:37
