Installation Instructions - 43
Checking after Installation
Test run after installation
Check for water leakage, abnormal noise,
and proper drainage.
Perform the following procedures
WITHOUT laundry in the drum.
1. Turn on the tap.
2. Close the door.
3. Please spin after moved this washing
machine.
Press the On button. You have to
select “Quick 50” course and “Spin
only” mode. Then, press the Start
button.
After the water is drained, start a test
run.
4. While holding down the Speed/Eco
and Easy Ironing buttons, press the
On button.
5. When the display appears as below
(3 seconds), press the Speed/Eco
button.
The remaining time is displayed as shown
below.
The test is run for approximately 3 minutes.
Check the following:
- Is there any abnormal noise?
If so, make sure that the appliance is
level.
- Is there any water leakage?
If so, make sure that the hoses are
properly connected.
The following errors may occur:
- Are the hoses properly connected?
Is the drain clogged?
- Have you properly connected the water-
supply hose and turned on the tap?
After the appliance has recovered from
an error, reopen and reclose the door to
resume the test.
NA-140_168_148VS4_WGB_En.indb 43
2013/11/06 19:06:42