Troubleshooting - 35
Error Display
Unable to drain
What to do
Check the drain hose for any of the following problems.
- It clogs up.
- Its tip is immersed in water.
- It extends further than 3 m.
- The water is frozen.
Clean the drain filter if it clogs up. (See page 29.)
After correcting the problem, open and close the door, and then
start the wash again.
Door is open
What to do
Make sure that the door is shut properly.
Unable to spin-dry
The appliance has been designed to detect unbalanced loads,
particularly small loads, in order to ensure quiet operation and
achieve the best results.
This is not a malfunction. Perform any of the following solutions.
What to do
- If the laundry is too heavy, untangle clumps of clothing.
- If the laundry such as a blanket is too heavy, reduce the load.
- If the laundry is too light, add one or two bath towels.
- If the appliance is on an unstable or uneven surface, change
the setting location.
After correcting the problem, open and close the door, and then
start the wash again.
Unable to supply
water
What to do
Check for any of the following problems.
- The tap is closed.
- The water pipe or hose is frozen.
- The water supply has been disrupted.
- The water supply filter is clogged. (See page 30.)
After correcting the problem, open and close the door, and then
start the wash again.
If the red mark appears in the hose with a water supply valve, the
water supply has stopped.
You should replace with a new hose.
Hose with water supply valve (No.AXW12C-7SR0)
An error display starting with H.
What to do
Press the Off button. If the display stays on, or if it reappears
when you press the Start button, unplug the appliance and
contact your local Customer Communications Centre.
NA-140_168_148VS4_WGB_En.indb 35
2013/11/06 19:06:40
