Panasonic KXF-193C, Operating Instructions Manual, Page: 99 / 120

Page 7-11
TROUBLESHOOTING
7
Check and Solutions
7-2-10 PCB Recognition Error
1. Moving the camera to the recognition mark position by inching and recog-
nize again. (Fig. 1)
Check the error screen, and when the recognition mark is not at the center of recognition screen,
move the recognition mark to the center by
UNLOCK
and , and press
UNLOCK
and Re-recog . The
operation is restarted.
2. Re-recognizing the recognition camera or board after cleaning
Check the error screen, and clean the mark if it is dirty, then press
UNLOCK
and Re-recog . The
operation is restarted.
3. Re-recognizing after entering proper coordinates
∗
When the recognition error is found again, No recog and PCB board are displayed additionally.
Select either of them (Fig. 3). To quit automatic operation and teaching, press .
(Fig. 2) (Fig. 1)
Re-recog The board recognition is carried out again.
No recog The next movement is carried out without
recognition.
Pass The recognition error board is passed
during the automatic operation.
Img move rsps The moving distance of one pressing
is set.
Low : 0.01 mm, Middle : 0.1 mm,
High : 2.00 mm
(red arrow mark) The recognition screen moves to
the (red arrow mark) direction.
(Fig. 3)
2
1
193C-E-OMA07-A01-04