LED Patterns
LEDs indicate the operational status of the unit, as follows:
LED pattern
Status
Light blue on
•
Starting up
Slow blue flashing
•
Idle state
Blue on
•
In a video conference call (including when dialing, receiving a video
conference call, and being disconnected)
Orange on
•
Self diagnosis is being performed.
Orange flashing
•
Mismatch of field frequency
*1
between the unit and display. (After 30 seconds
the flashing will stop and the unit will restart in safe mode.)
Red on
•
An error has occurred.
•
Maintenance is being performed.
Red flashing
•
A serious error has occurred.
Off
•
Power is off.
•
In screen standby mode
*1
Devices such as the display or video camera operate with a particular field frequency, depending on their video format. For details
on the field frequency, contact your dealer.
Screen Standby
When there is no video conference call transmission, and the remote control is not operated for more than 10
minutes (default), or when the remote control’s
[Video Out On/Off]
button is pressed, the unit enters screen
standby mode. Video out to the display is suspended and the status LED turns off.
Screen standby mode ends when the remote control is operated, or when a video conference call is received.
Notice
•
If screen standby mode ends and no image is visible, check to see if the display or video camera’s
power saving settings are enabled. Check each device’s manual for more information about its power
saving settings.
Note
•
You can change the length of time until the unit enters screen standby mode (Page 92).
•
The unit will not enter screen standby mode while displaying a computer’s screen or a sub video
camera’s image, even if the remote control is not operated for a period of time.
•
When the remote control is operated and screen standby mode ends, the Home screen will be
displayed.
•
If a button is pressed on the remote control to end screen standby mode, that button’s operation is not
performed in that case.
•
If screen standby mode begins while editing information in the contact list or other screen, any unsaved
changes will be lost.
•
It takes about 7 seconds to return from screen standby mode. (The length of time may vary depending
on the type of display you are using.)
22
Operating Manual
Document Version 2011-04
Preparation
