Connection of External Sensors and External Relays to DPH2 Card
Use 8-pin and 10-pin terminal block (included with the card) for connection.
1.
While pressing down on the hole at the top of the terminal block using a screwdriver, insert the wire into
the side hole as shown below. Repeat this procedure for other external sensors and external relays. Refer
to "2.5.2 DPH2 Card (KX-TDA3162)" for pin assignments.
External Sensor/
External Relay Device
2.
Attach the terminal block to the connector of the DPH2 card in the PBX.
To external sensors
To external relays
220
Installation Manual
2.10.1 Connection of Doorphones, Door Openers, External Sensors, and External Relays
Summary of Contents for KX-TDA30
