41
Setting up the Printer
4
Set the source item in the properties window to “Manual Feed” or “MP Tray”
(see
page 98
).
— To print continuously from the MP tray, set the source item to MP Tray.
— To print a sheet of paper from the MP tray, set the source item to Manual Feed.
5
Select “Thick” from Paper Type List Box of the printer driver.
N
OTES
•
Do not use an envelope curled down side, refer to the figure left below.
•
When wrinkle occurs, try printing with the envelope flap tucked in as shown right below.
To load envelopes into the OPT cassette, see
page 165
.
Labels automatically feed from the MP tray.
N
OTES
•
About the available labels, see
page 203
.
•
Use full label sheet. Partial sheets may cause labels to peel off during printing, resulting in a
paper jam.
•
Avoid printing labels if the temperature is too high; doing so may damage consumables. The
adhesive material should be stable at 205°C (400°F), the printer’s maximum temperature.
•
Do not use labels that have the backing sheet exposed.
•
Do not print on both sides of labels.
•
Select “Thick” from Paper Type List Box of the printer driver.
You cannot load labels from the cassettes. Use the MP tray for loading labels.
Loading labels in the MP tray