Panasonic JS-925WS-010, Service Manual

Page: 65 / 188

57
Modem Status : XX Expected : XX Loopback Test among DSR of the modem status,
CTS, RI, and RLSD is one.
6 RS232C Data Real loopback interrupt request failed
LINE STATUS : XX The time-out was done without generating the
interrupt of the cereal in External Loopback Test.
7 RS232C Serial port data real loopback Test failed
Line status : XX The line change of state interrupt went up in
External Loopback Test, and the flaming error or
the parity error or the overrunning error occurred.
8 RS232C Data real loopback receive failed
LINE STATUS : XX Bit (Line Status Bit0 ) with received data is not one
though the reception interrupt goes up in External
Loopback Test.
9 RS232C Serial port data real loopback Test failed
Xmit : XX Recv : XX In External Loopback Test, received data is not
corresponding to transmission data.
10 RS232C Data real loopback transmit failed
Line status : XX The transmission data register is not empty though
the transmission interrupt goes up in External
Loopback Test. (Line Status Bit5 )
3.5.5. Audio
Test
Only OK or NG
3.5.6. Customer
Display Test
Only OK or NG
3.5.7. Touch
Panel Test
No. Message Cause
1 CALTRN Command Receive Retry Out After calibration had ended, the return code of the
CALTRN command (correction factor demand
command) was illegal.
2 File Access Error It failed in writing the correction data in the file.
3.5.8. Drawer Test
No. Message Cause
1 Already Open The drawer is already open.
2 Drawer 1 or 2 is open? Open the Drawer, check the state of the Drawer
3.5.9. Ether
Test
No. Message Cause
1 NG [ TX NOT READY ] The time-out was done without the transmission
OK bit becoming one after data had been
transmitted.
2 NG [ RX NOT READY ] The time-out was done without the reception OK
bit becoming one by data receive standby.
3 NG [ DATA ( S-XX R-XX) ] Transmission data doesn't match to received data.
4 NG [ TXT SIZE ERROR ] The size of received data is illegal.
5 Write XXXX : Read XXX NG [ EEPROM ERROR] It failed in writing EEPROM
3.5.10. USB Test
No. Message Cause
1 USB device not connected The USB device is not connected.
2 Low speed device connected Rorspedodebais is connected.
3 High speed device connected A high-speed device is connected.
4 USB device disconnected The USB device was removed.
3.5.11. Heat Run Test
None
3.5.12. Input PASSWORD (at entering Interactive Administrator Mode )
No. Message Cause
1 NG, Password is not correct. The input password is wrong.