58
Configure the network settings [NETWORK]
Configure the network settings. When connecting the camera to a network, it is necessary to configure the network
settings such as IP address, etc.
The settings can be configured on the "NETWORK SETUP" page. Refer to the operating instructions for descriptions
of how to display the "NETWORK SETUP" page. Refer to page 27 for how to display the "NETWORK SETUP" page
using a PC.
Notes:
• Configure the network settings on the "NETWORK SETUP" page when network connection is not established
yet. It is unnecessary to configure the network settings on this page when configuring the network settings on the
[Network] tab on the [Network setup] page (
☞
page 41) or using the Panasonic IP setting software.
• Before configuring the settings, refer to the network administrator or the Internet service provider for the following
information.
• IP address
• Net mask
• Default gateway (when using the gateway server/router)
• HTTP port Number
NETWORK SETUP page
[DHCP]
Select "ON" or "OFF" to determine whether or not to use
the DHCP function.
[IP ADDR]
When not using the DHCP function, enter the IP
address of the camera.
[NETMASK]
When not using the DHCP function, enter the net mask
of the camera.
[GATEWAY]
When not using the DHCP function, enter the default
gateway of the camera.
[HTTP PORT NO.]
Assign the port numbers independently.
Note:
Refer to page 41 for further information about the
network settings.
The default network settings are as follows.
DHCP:
OFF
IP ADDRESS:
192.168.0.10
NETMASK:
255.255.255.0
GATEWAY:
192.168.0.1
HTTP PORT NO.: 80
**NETWORK SETUP**
DHCP OFF
IP ADDR 192.168. 0. 10
NETMASK 255.255.255.128
GATEWAY 192.168. 0. 1
HTTP PORT NO. 80
RET TOP END
