1
Chapter
Maintenance
and
Inspections
(Continued from the previous page)
Item
Message
Description
Measure
HDD
(USB
HOST
MODE)
CANNOT ACCESS
CARD!
An error occurred during P2 card access.
Check P2 card.
CANNOT ACCESS
TARGET!
An error occurred during hard disk access. Check hard disk status and connection.
CANNOT FORMAT!
The hard disk cannot be initialized.
Connect another hard disk drive.
CANNOT RECOGNIZE
HDD!
The destination target cannot be properly
recognized.
Reboot the hard disk or connect a different
hard disk.
CARD IS EMPTY!
CANNOT COPY!
The P2 selected for copying is empty.
Copying is not performed since the card
is empty.
HDD CAPACITY FULL! Not enough space left on the hard disk.
There is not enough space on the
connected hard disk. Use a new hard disk
or formatted hard disk.
HDD DISCONNECTED! The unit is not connected to a hard disk.
Reconnect the USB cable. If the hard disk
does not operate normally, turn it off and
turn it back on again.
MISMATCH
COMPONENT!
Copying cannot be made because the
destination card is in the wrong format.
Use a P2 card with the same model
number or import video in clip units.
P2 CARD IS
UNFORMATTED!
The P2 card is not formatted.
Use a formatted P2 card.
PLEASE FORMAT P2
CARD!
This warning indicates that data could not
be imported from a hard disk to a P2 card
because the P2 card contained recorded
data.
You cannot copy to a P2 card that
contains data. Format the card on a P2
device and copy again.
TOO MANY
PARTITIONS!
There are too many partitions.
Hard disks can handle up to 23 partitions.
Use a new hard disk or formatted hard
disk.
TOO MANY TARGETS! Multiple devices are connected.
Disconnect devices, turn off the unit and
turn it back on again.
UNKNOWN DEVICE
CONNECTED!
The connected DVD drive is not compatible.
Disconnect devices, turn off the unit and
turn it back on again.
VERIFICATION FAILED! The compare check after copying failed.
Copy the data again.