12
VQT1Y31
Quick Guide
Charging the battery
Connect the AC cable to the AC adaptor and
the AC outlet.
Insert the battery into the AC adaptor by
aligning the arrows.
Inserting the battery
Install the battery by inserting it in the direction
shown in the figure.
Insert the battery until it clicks and locks.
Inserting/removing an SD card
1) Open the LCD monitor.
Check that the access lamp has gone off.
2) Open the SD card cover by sliding the OPEN
lever
.
3) Insert/remove the SD card.
Face the label side
in the direction shown in
the illustration and press it straight in as far as
it will go.
Press the center of the SD card and then pull it
straight out.
4) Securely close the SD card cover.
Securely close it until it clicks.
Charging lamp
[CHARGE]
Lights up:
Charging
Goes off:
Charging
completed
Access lamp [ACCESS]
When this unit is accessing the SD card, the
access lamp lights up.
