Panasonic EYADA Series, Operating Instructions Manual

Page: 110 / 120

52
EN
ERROR CODES
If there is any problem, an error code blinks on the display of
the tool.
Consult the table below and take a necessary action.
• [E0] to [E7]
Pressing the OK button will clear the error display.
• [EE] and [F2] to [Fb]:
Press the OK button. Or pressing a switch will clear the error
display.
If the problem persists, stop the use immediately.
Bring it to your dealer.
Display Possible cause Action
In the setting mode, an
inappropriate setting is
input.
Review the setting to correct
it.
P. 54
The tool is hot.
Interrupt the work and wait
for it to cool down before use.
The internal protective
sensor is out of order.
Send the tool for repair.
The tool is overloaded
or the motor is out of
order, for example.
Eliminate the condition(s)
that caused the overload and
recheck the condition.
When this does not eliminate
the problem, send the tool
for repair.
A cord or cords are not
correctly connected.
Check whether the cords
are correctly connected and
whether no cords are broken.
When no abnormality is
found in the cords, the power
adapter may be failed. Send
the tool for repair.
The tool circuit is failed or
out of order, for example.
Send the tool for repair.
The communication
cable is broken or poorly
connected, for example.
Check the communication
cable.
EY9310ADA202.indb 52 EY9310ADA202.indb 52 2023/12/07 19:02:04 2023/12/07 19:02:04