Panasonic EYADA Series, Operating Instructions Manual

Page: 100 / 120

42
EN
BASIC SETTING MENU (b + NUMBER)
(cont.)
b3 External-Input Drive Permission Setting
When connected to an external
device with a communication cable,
this unit can be controlled from the
external device.
P. 44
In work where multiple tools are used,
you can prevent tool mix-ups by
permitting the start only for the tools
to use and by disabling the start of
tools that are not permitted.
Also, you can make the detection
lamp of the Electric Screwdriver being
controlled blink or turn off.
You are notified of the Electric Screwdriver
to use, by blinking its detection lamp.
* You can also disable blinking.
Blinking
green Work
permitted
When drive permission is given
If you use an improper Electric Screwdriver,
it will not start and its detection lamp will
blink red with a buzzer.
Blinking red
Not blinking
Buzz
When drive permission is not given
■
Setting Procedure
Switch to setting mode.
Set the forward/reverse lever to
the trigger switch lock position, and
hold down the OK button.
P. 22
Choose “b3” by pressing
the ▲ and ▼ buttons, and
press the OK button.
A set value appears on the display.
Select a desired one by
pressing the ▲ and ▼
buttons.
The default is “_ _”.
Display
External-input drive
permission
OFF (Not permitted)
ON (Permitted, lamp
blinking)
ON (Permitted, lamp
off)
Press the OK button to
confirm it.
When the setting is completed, a
buzzer sounds long (a long beep),
and the display returns to the menu
screen.
Back to Operation Mode.
Hold down the OK button.
P. 22
EY9310ADA202.indb 42 EY9310ADA202.indb 42 2023/12/07 19:02:02 2023/12/07 19:02:02