Panasonic DLP PT-FRZ50, Operating Instructions Manual

Page: 97 / 186

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 97
Setting [NO SIGNAL SHUT-OFF]
This is a function to automatically set the power of the projector to standby mode when there is no input signal for
specific period. The time before switching to standby can be set.
1) Press
as
to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f
The [ECO MANAGEMENT] screen is displayed.
3) Press
as
to select [NO SIGNAL SHUT-OFF].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[DISABLE] Disables the no signal shut-off function.
[10MIN.] - [90MIN.] Sets the time in increments of 10 minutes.
Setting [STANDBY MODE]
Set the power consumption during standby and whether to enable the [QUICK STARTUP] function.
1) Press
as
to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f
The [ECO MANAGEMENT] screen is displayed.
3) Press
as
to select [STANDBY MODE].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[NORMAL] Select this item when using the network function during standby.
[ECO] Select this item to reduce power consumption during standby.
f
Proceed to Step 5) when [NORMAL] is selected.
5) Press
as
to select [QUICK STARTUP].
6) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[OFF] Disables the [QUICK STARTUP] function.
[ON]
Enables the [QUICK STARTUP] function until the specified time set in [VALID PERIOD] elapses after
the projector enters the standby mode. The time until the projection starts after the power is turned on
will be reduced during the period when the [QUICK STARTUP] function is valid.
f
Proceed to Step 7) when [ON] is selected.
7) Press the <ENTER> button.
f
The [QUICK STARTUP] screen is displayed.
8) Press
qw
to switch [VALID PERIOD].
f
The items will switch each time you press the button.
[30MIN.]
Sets the time until the [QUICK STARTUP] function is disabled after the projector enters the standby
mode.
Select a desired valid period.
[60MIN.]
[90MIN.]
Note
f
When [STANDBY MODE] is set to [NORMAL], the network function can be used during standby.
f
When [STANDBY MODE] is set to [NORMAL], the <DC OUT> terminal can supply power even in standby state. If set to [ECO], the <DC
OUT> terminal can not supply power in standby state.
f
When [STANDBY MODE] is set to [ECO], the network function and the audio output function cannot be used during standby. Also, some
RS-232C commands cannot be used.
f
When [STANDBY MODE] is set to [ECO], it takes longer for the projection to start after the power is turned on, compared to when set to
[NORMAL].
f
[STANDBY MODE] is fixed to [NORMAL] when the [PROJECTOR SETUP] menu → [SCHEDULE] is set to [ON].