Panasonic CS-E12QB4RW, Service Manual

Page: 39 / 106

39
11.2.8 Auto Switch Operation
The following operations can be performed by
pressing the “AUTO” switch.
1 AUTO OPERATION MODE
The Auto operation will be activated
immediately once the Auto Switch is pressed.
2 TEST RUN OPERATION (FOR PUMP
DOWN/SERVICING PURPOSE)
The Test Run operation will be activated if the
Auto Switch is pressed continuously for more
than 5 sec. to below 8 sec. A “pep” sound will
occur at the fifth sec., in order to identify the
starting of Test Run operation.
11.2.9 Changing the Remote Control Transmission Code
1 Press AUTO SW continuously for more than
11 sec to below 16 sec, A “pep”, “pep”, “pep”
sound will occur at the eleventh sec.
2 Press the “A/C RESET” button once remote
control signal will activate the remote control
transmission code setting mode.
3 Press “OFF/ON” button. The new Remo-Con
No. will be accepted and memorized, after
which the new Remo-Con No. can be used.
Remo-Con No. Change in Remote Control
1 Remove the batteries from the battery
compartment of the Remote Control.
2 On the left side of the battery compartment,
there is a small opening in the centre in which
Jumper (J_A) can be seen. In the accepted
Remo-Con PCB shown beside, Jumper (J_B)
can be seen.
J_A J_B Remo-Con No.
Short Open A(Default)
Open Open B
Short Short C
Open Short D