![background image](http://html.mh-extra.com/html/panasonic/cf-y2-series/cf-y2-series_service-manual_264457020.webp)
4.4.3. Diagnosis by Error Code
Error code
Message
Error Description
Possible faulty part
0200
Failure Fixed Disk
Fixed disk in not working or not configured properly.
HDD
Run the Setup Utility and check that the hard disk
Main board
capacity is displayed at [Primary Master].
If the [None] is displayed, disk error is occurred.
0211
Keyboard error
Keyboard not working. Confirm the keyboard is connected Keyboard
to the computer and that a key is not being held down.
0212
Keyboard Controller Failed Keyboard controller failed test.
Main board
May require replacing keyboard controller.
0230
System RAM Failure
System RAM failure at offset
nnnn of the 64k block at
Main board
at offset :
nnnn
which the error was detected. If you installed RAM module,
remove the RAM module and reinstall it.
0231
Shadow RAM Failure
Shadow RAM failure at offset
nnnn of the 64k block at
Main board
at offset :
nnnn
which the error was detected. If you installed RAM module,
remove the RAM module and reinstall it.
0232
Extended RAM Failure
Extended memory not working or not configured properly
Main board
at offset :
nnnn
at offset
nnnn.
Extension memory
0250
No battery on the system
CMOS backup battery exhausted.
Lithium battery
Battery replacement is required.
0251
System CMOS checksum
System CMOS has been corrupted or modified incorrectly, Incorrect Setup
bad
perhaps by an application program that changes data
Lithium battery
-Default configuration used stored in CMOS.
The BIOS installed Default SETUP Values. If you do not
want these values, enter Setup and enter your own values.
If the error persists, check the system battery or contact
Panasonic.
0260
System timer error
The timer test failed. Requires repair of system board.
Main board
0270
Real time clock error
Real-time clock fails BIOS test. May require board repair.
Main board
0271
Check date and time
Incorrect date and time on the system.
Incorrect Setup
settings
Set the correct date and time using the setup utility.
0280
Previous boot incomplete
Previous POST did not complete successfully.
Boot-up failure
-Default configuration used POST loads default values and offers to run Setup.
If the failure was caused by incorrect values and not
corrected, the next boot will likely fail.
02D0
System cache error
CPU trouble.
Main board
-Cache disabled
02F5
DMA Test Failed
Server BIOS2 test error: Cannot write to extended DMA
Main board
22
17
Summary of Contents for CF-Y2 Series
