![background image](http://html.mh-extra.com/html/panasonic/cf-y2-series/cf-y2-series_service-manual_264457029.webp)
6.2.4. Removing the LCD Block
Preparation: Make sure that the steps in sections 6.2.1 to
6.2.3 have been taken first.
(The entire unit is now standing upright with the LCD
Block open at a 90-degree angle.)
1. Disconnect the LCD Cable from the connector (CN8) on the
Main Board.
2. Disconnect the Inverter Cable from the connector (CN11).
3. Remove the LCD Hook, lift the front end of the Top Cabinet
Ass’y using the hinge as a fulcrum, and move the LCD
Block from the Top Cabinet Ass’y in the direction of the
arrow to remove it.
*The Conductive Cloth cannot be re-used.
Use a new one instead.
6.2.5. Removing
the
HDD
Preparation: Make sure that the steps in sections 6.2.1 to
6.2.4 have been taken first.
1. Remove the HDD by lifting it and disconnecting the HDD
Flexible Connector.
* Take care to avoid bending the connecting pins on the
HDD side when disconnecting the HDD Flexible Connector.
6.2.6. Removing the MDC Modem Board
Preparation: Make sure that the steps in sections 6.2.1 to
6.2.5 have been taken first.
1. Remove the two Screws (K).
Screw (K): DXHM0056ZA
2. Disconnect the MDC Board Block from the
Pad/HDD FPC
connector.
3. Peel off the tape, disconnect the Modem Cable, and
remove the Modem Jack.
6.2.7. Removing the LED/Power Board
Preparation: Make sure that the steps in sections 6.2.1 to
6.2.5 have been taken first.
1. Remove the two Screws (L), and remove the HDD Angle.
Screw (L): DXHM0056ZA
2. Disconnect the FPC (HDD/Angle) from the connector
(CN910).
3. Remove the Screw (M), and remove the LED/Power Board.
Screw (M):DXHM0056ZA
26
Summary of Contents for CF-Y2 Series
