3
Following the display, press .
Input the password set in step and select [OK], then select [Close] at the [Welcome] display.
13
9
Select [Restart Computer]. Select "Windows NT Workstation Version 4.00" and press .
6
15
14
20
18
Install the Phoenix APM 2.0 for NT by following the on-screen instructions.
When the installation completes, select [Don't Restart Now].
Install the Phoenix Card Executive™ for NT by following the on-screen instructions. When
the installation completes, select [Restart Now].
The [Begin Logon] display will appear. Perform the operation in step .
Calibration is executed automatically. Touch the center of each red cross by
following the on-screen instructions. At this time, a timeout will occur if no
input is made in a ten-seconds period. (
"Touchscreen"). If the red
cross is not touched within the period, select [Calibrate] in [Start] - [Pro-
grams] - [Updd].
11
12
Select [Next] at the [Card Executive 2.0 for NT Diagnostics].
Select [Next], then select [Finish].
Windows will restart. Select "Windows NT Workstation Version 4.00" and press .
17
The [Begin Logon] display will appear. Perform the operation in step .
19
10
10
Set the correct settings for all items in [Control Panel]-[Regional Settings] and [Date/Time] etc.
It takes several minutes for the necessary files to be copied. If the computer enters the ECO
mode, the power to the LCD is automatically turned off. In this case, press a key unrelated
to the direct triggering of a selection, like .
Ctrl
Install the modem driver by following the on-screen instructions.
At the [COM Port Number], select [COM3], then select [OK].
Enter
Install the Touchscreen driver by following the on-screen instructions.
At the [Would you like to restart now], select [No]. Close the [Updd] window.
Install the WorldPort utility by following the on-screen instructions.
Install the CrystalWave SoftSynthesis Installation for NT4 by following the on-screen instructions.
When the installation completes, select [Cancel].
16
21
10
23
In [Start] - [Run], input [c:\util\msupdate\EN-X86-Q234680], then select [OK].
Follow the on-screen instructions. (EN-X86-Q234680.EXE is a file for IE4.01 SP2 Y2K.)
If the display asks you to restart Windows, select [Yes].
NOTE
8
Ctrl
+
Alt
+
Del
NOTE
Select [Do not connect this computer to a network at this time], then select [Next].
(Settings can be made for a network even after Windows starts up. In this case, be sure
to read [When Adding New Software or Hardware Components] in the Reference Manual
[Technical Information].)
When establishing settings for a network:
The settings will vary for different network environments depending on the network
system being used. For more details, ask your system administrator or the person in
charge of the network. Follow the on-screen instructions.
(If the LAN driver is in the floppy disk, install the driver by using the SuperDisk Drive
Pack after Windows Setup.)
Double-click the [Internet Explorer] icon to install Internet Explorer.
Follow the on-screen instructions.
At the [Installation Option], by clicking , select [Full Installation], then select [Next].
At the [Confirm File Replace], press [No].
Windows will restart. Select "Windows NT Workstation Version 4.00" and press .
Close the unnecessary windows.
Enter
Install the Crystal Audio driver by following the on-screen instructions.
22
Enter
