![background image](http://html.mh-extra.com/html/panasonic/bb-hcm403a/bb-hcm403a_operating-instructions-manual_256281058.webp)
Operating Instructions
58
4.
Click [Go to UPnP page].
•
The UPnP page is displayed.
2.7.1
Connecting the Camera to a Router that Supports
UPnP
™
(IPv4 Only)
To allow access from the Internet with a router supporting UPnP
™
, follow the
procedures shown in Getting Started.
Note
•
On some routers, the UPnP
™
feature is disabled by default. Enable your
router's UPnP
™
feature following the router manual before you set up the
camera. See the Panasonic Network Camera support website at
http://panasonic.co.jp/pcc/products/en/netwkcam/
for details.
•
If a maximum idle time is set in PPPoE or PPTP connection with your ISP,
disable it on the router. See the router manual for details.
2.7.2
Connecting the Camera to a Router that Does Not
Support UPnP
™
(IPv4 Only)
To allow access from the Internet with a router that does not support UPnP
™
, follow
the procedures below.
1.
Select [Static] on the Network (IPv4) page.
2.
Enable port forwarding*
1
on the router.
Using the IP address and port number noted on step 1-(3), enable port
forwarding on the router. See the router manual for how to enable port
forwarding.
3.
Register with the Viewnetcam.com service.
(1)
Access the camera (see page 11).
(2)
Click the [Setup] tab at the top of the page.
(3)
Select [Static] on the Network page.
•
The Static IP Address Configuration page is displayed. Make a
note of the IP address and port number, since they are required to
enable port forwarding on the router.
Note
•
You must assign a unique IP address and a unique port number
to each camera on the LAN.
(4)
Click [Save] without changing the settings.
(5)
Click [Restart].