-15-
■
Connecting the Pan/tilt Head AC Adapter
Connect the Pan/tilt Head AC Adapter AW-PS300.
AC IN
OPTIONSW
CONTROL OUT
OPTIONSW
CONTROL IN
LAMP
CONTROL
DC 15V
OUT
OP
C S
+ –
LAMP AC OUT ( )
MIN 250W
MAX 500W
[ ˝ … c
¤ '
•
P/T CONTROL IN
(CONTACT/RS-232C)
Wiring
q
Wiring
w
Wiring
e
about 1 cm
Pan/tilt Head AC Adaptor AW-PS300
Terminal board
q
G/L IN
Genlock signal input connector
Connect it to the G/L OUT connector on the Multiport
Hub (AW-HB505) or Control Panel (AW-RP501) with a
BNC coaxial cable.
w
CAMERA CONTROL IN
Camera control signal connector
Connect it to the CAMERA CONTROL OUT connector
on the Multiport Hub (AW-HB505) or Control Panel
(AW-RP501) with a BNC coaxial cable.
e
VIDEO OUT
Camera video output connector
Connect it to the VIDEO IN connector on the Multiport
Hub (AW-HB505) or Control Panel (AW-RP501) with a
BNC coaxial cable.
r
P/T CONTROL IN (SERIAL)
Pan/tilt head control signal connector
Connect it to the PAN/TILT CONTROL OUT connector
on the Multiport Hub (AW-HB505) or Control Panel
(AW-RP301, AW-RP305, or AW-RP501) with a 10BASE-
T straight cable (UTP category 5).
Terminal Board DC 12V IN (Wire
q
)
Connect it to DC 15V OUT on the Pan/tilt Head AC
Adapter AW-PS300.(The AC adapter is set to an output
voltage of 15 V, considering a voltage drop due to an
extended cable between the pan/tilt head and the
adapter.)
Solder the wire end
if possible.
