-3-
PRECAUTIONS
SW 2
SW 1
SW 3
Battery
• Avoid using the pan/tilt head in the kitchen or other
places full of steam and oil fume.
• The pan/tilt head has a maximum load capacity of 4
kg
.
Do not use it for a load over 4
kg
.
• Do not install the pan/tilt head outdoors, or at a place
over 45°C, or at a cold place below
−
10°C.
Ambient humidity must be less than 90%.
• Mounting screws must be locally purchased because
they are not supplied.
Choose screws appropriate to the material of the
mounting place and the load on the pan/tilt head.
• Use only with AC Adaptor, Model AW-PS300.
• In handling the pan/tilt head, be sure to hold it by the
base.
Do not lift the pan/tilt head by the rotary part of it.
Otherwise, something may go wrong with the head.
• Do not turn the pan/tilt head by the rotary part of it.
Otherwise, something may go wrong with the head.
• Dropping the pan/tilt head or subjecting it to a strong
shock can cause a failure or an accident.
• Keep the pan/tilt head more than 1 meter away from
the monitors.
• The pan/tilt head uses a manganese dioxide lithium
battery (CR2032).
Be sure to remove the battery before disposing of the
pan/tilt head or the printed wiring boards in the head.
Be sure to dispose of a removed battery, or an old bat-
tery removed to be replaced, according to the applica-
ble provisions of law.
Do not dispose of it as ordinary trash.
The battery is located as shown in the figure below. To
remove the battery, refer to Battery Replacement
under the Replacement of Expendables at page 20.
Danger of explosion if battery is incorrectly replaced.
Replace only with same or equivalent type recommend-
ed by the manufacturer. Dispose of used battteries
according to the manufacturer`s instructions.
Caution
