-9-
SW 2
SW 1
SW 3
SW 2
SW 1
SW 3
DESKTOP
HANGING
CONTACT/RS232C
SERIAL
■
Before Installing
Before installing the pan/tilt head, be sure to make the
following settings and changes.
●
Setting the Mounting Direction Switches
and Setting Others in Case of Using
Contact Type Controller, RS232C
To mount the pan/tilt head upright, or to control the
pan/tilt head with a contact type controller or RS-232C,
make the following settings.
(This is unnecessary in case of controlling a suspend-
ed pan/tilt head from a control panel.)
• Remove the cover screws from the pan/tilt head and
carefully remove the cover.
(Be careful of the tally Indicator leads when removing
the cover.)
• Set switches SW1, SW2, and SW3 on the front PCB as
follows:
Pan/tilt head suspended:
Set SW1 and SW2 to the
down position. (Default)
Pan/tilt head upright:
Set SW1 and SW2 to the up
position.
Pan/tilt head controlled with control panel:
Set SW3
to the down position. (Default)
Pan/tilt head controlled with contact type controller
with RS-232C:
Set SW3 to the up position.
• Place the cover back on and fasten it with the screws.
(Be careful not to get the leads caught.)
