Panasonic AW-UE20KE, Operating Instruction

Page: 26 / 126

26
1
2
3
5
7
6
8
9
10
11
12
13
14
4
9 Pan-tilt buttons and menu operation buttons
(1)These are used to change the unit’s direction. The unit is tilted in the
up/down direction using the [
▲ ] and [ ▼ ] buttons and panned in the left/right
direction using the [ ◄ ] and [ ► ] buttons.
The [ ○ ] button does not work during tilting and panning.
When the [ ▲ ] or [ ▼ ] and [ ◄ ] or [ ► ] buttons are pressed at the same time, the
unit moves diagonally.
(2) The buttons are used for menu operations when the unit displays the
camera menus.
Use the [
▲ ] and [ ▼ ] buttons to select the menu items.
When a selected item has a sub-menu, the sub-menu will be displayed by
pressing the [

] or [ ► ] button.
When the [

] or [ ► ] button is pressed on the setting menu at the bottom
hierarchical level, the new setting is entered.
10 SLOW button
This is used to change the movement speed at which the panning, tilting,
zooming and focusing operations are performed to the low speed.
11 MENU button
Press and hold for 2 seconds to display the camera menu of the unit.
12 HOME button
When this is pressed for 2 seconds, the unit’s direction (panning or tilting)
returns to the front of the unit and the zoom level of the unit is changed back
to x1.
13 ZOOM button
These are used to adjust the digital zoom.
The zoom is adjusted in the wide-angle using the [W] button and in the
telephoto using the [T] button
14 FAST button
This is used to change the movement speed at which the panning, tilting,
zooming and focusing operations are performed to the high speed.
This unit can be operated by remote control using a wireless remote control (model number: AW-RM50AG) purchased
separately. Check out the following points before using the wireless remote control.

Point the wireless remote control at the unit’s wireless remote control signal light ‑ sensing area (front side
and back side), and operate it within a range of 10 meters (32.8 ft.) from the area.

Refer to <Layout of wireless remote control signal light-sensing areas> on the below.

The signal sensing distance is reduced if the angle at which the wireless remote control signals are sensed
is increased.
The light-sensing sensitivity is reduced to about one-half when the wireless remote control is pointed at an angle of
40 degrees from each position in front of a wireless remote control signal light-sensing area (front panel or back
panel).

If the unit is installed near fluorescent lights, plasma monitors or other such products or if the unit is
exposed to sunlight, the effects of the light may make it impossible for the unit to be operated using the
wireless remote control.
Be sure to follow the steps below for installation and use.

Take steps to ensure that the wireless remote control signal light- sensing area will not be exposed to the light
from fluorescent lights, plasma monitors or other such products or from the sun.

Install the unit away from fluorescent lights, plasma monitors and other such products.