1 – 7
Aquarea air/water heat pump – Installation manual for monobloc and split systems C, D and E series 05 / 2014
1
Introduction
Introduction
Tools required | To be provided by custome
We recommend that you use the following tools:
• Phillips-head screwdriver
• Spirit level
• Electric drill
• Set of spanners
• Knife
• Tape measure
• Multimeter
• Torque wrench, 39 .2 Nm
• Torque wrench, 58 .8 Nm
• Gas leak detector
1.5 Tools required
We recommend that you use the following tools:
• Philiips head screwdriver
• Spirit level
• Electric drill, drill bit (ø 70 mm)
• Allen key (4 mm)
• Set of spanners
• Pipe cutter
• Deburrer
• Knife
• Gas leak detector
• Tape measure
• Thermometer
• Multimeter
• Torque wrench, 18 Nm
• Torque wrench, 55 Nm
• Torque wrench, 65 Nm
• Vacuum pump
• Manometer station
1.5.2 Split systems
The following components must be provided by the customer:
• 2-way directional valve set
• 3-way directional valve set
• Analogue room thermostat (e .g .
RAA20 Siemens) or program-
mable room thermostat
(e .g . REV200 Siemens)
• Anchoring to prevent tipping over
• Dirt trap (mesh width at least
500 to 600 µm)
• Propylene glycol antifreeze
mixture
• Flush-mounted box for fitting
the wired remote control
• Heating circuit mixer closed-
loop control
• Dew point monitor
• Device for draining the system
• Insulation for pipelines
1.6 To be provided by customer
1.6.1 Monobloc systems
The following components must be provided by the customer:
• Wall penetration or bushing
DN 70
• Sealant for wall penetration
• Drain hose internal diameter
15 mm
• Drain hose internal diameter
17 mm (if a drain elbow is used)
• Hose clamp
• Thermal insulation or filler to
seal the outdoor unit
• M8 hexagonal screws, washers
and anchors with threaded
inserts for the hydro module
mounting plate
• Insulation for pipelines
• Heating circuit mixer closed-
loop control
• Refrigerant R410A
(R407C for HT series)
• Vacuum pump for manometer
station
1.6.2 Split systems
1.5.1 Monobloc systems
