139
Connection with external device : Connection using the SDI IN connector (when AJ-YA350AG attached)
Conn
ec
tion wi
th
e
x
te
rnal
de
v
ic
e
1
Confirm that the HD/SD-SDI input board (AJ-
YA350AG: optional accessory) is attached to the unit
and that the wires are connected properly. For details,
refer to the installation manual for the AJ-YA350AG.
2
Confirm that the connected device has the same
signal format as camera-recorder.
3
When signals are input from the SDI IN connector, set
the REC SIGNAL in the setting menu to “SDI”. The
REC SIGNAL item will be selected from <SYSTEM
MODE> on the SYSTEM SETTING page.
Notes
z
If the HD/SD-SDI input board is not attached, REC
SIGNAL cannot be set to "SDI".
z
When nothing is connected to the SDI IN connector or
there is no input signal, images to be recorded will be
black and no sound will be recorded. Input the same
signals as the format set in the SYSTEM MODE item in
the setting menu through the SDI IN connector. If the
formats are different, data will not be properly recorded
on the P2 card.
z
Note the following points when the REC SIGNAL of the
setting menu is set to “SDI”.
Audio signals are input from the SDI IN connector.
Audio signals must be input synchronized with
video images. Data will be recorded as 48 kHz/4CH
(16 bit) on a P2 card.
When the REC SIGNAL item is set to “SDI”, signals
input from the GENLOCK IN connector are disabled
even if nothing is connected to the SDI IN connector.
Please note that there is a delay between video
images and voice signals when the unit is used on a
system synchronized with the reference.
z
UMID information, time code and user bits cannot be
recorded on a P2 card using the SDI IN connector.
Connection using the SDI IN connector
(when AJ-YA350AG attached)
AJ-HPX2000P(VQT1D27-5)E.book 139 ページ ２００９年１１月１２日 木曜日 午後８時１４分
