65
Displays
LACK OF REC CAPACITY!
There is not enough memory on the card for the
clips to be recorded. Insert a card with enough
memory on the card for the clips to be recorded.
HDD CAPACITY FULL!
The hard drive does not have enough free
memory. Use a new hard drive or formatted hard
drive since the connection destination target
does not have enough remaining memory.
TOO MANY PARTITIONS!
There are too many partitions. The maximum
number of partitions available on a hard drive
is 15 so use a new hard drive or formatted hard
drive.
HDD DISCONNECTED!
The hard drive has been disconnected. Re-
establish the USB connection. If the hard drive
still fails to operate properly, turn its power off,
and then turn it back on.
CANNOT FORMAT!
The media cannot be initialized (formatted).
Change the hard drive which is connected.
TOO MANY TARGETS!
A multiple number of devices have been
connected. After disconnecting the unnecessary
devices, turn the power of the required device off
and then turn it back on.
CANNOT ACCESS TARGET!
An error occurred while accessing the connection
destination target. Check the hard drive status
and connections.
CANNOT ACCESS CARD!
An error occurred while accessing the P2 card.
Check the P2 card.
MISMATCH COMPONENT!
Data cannot be copied because of a mismatch in
the memory or format of the copy source P2 card
and copy destination P2 card. Use P2 cards with
the right amount of memory.
UNKNOWN DEVICE CONNECTED!
A DVD drive or other devices which are
not supported have been connected. After
disconnecting the unnecessary devices, turn the
power of the required device off and then turn it
back on.
P2 CARD IS UNFORMATTED!
The P2 card has not been formatted. Use a P2
card which has been formatted.
CARD IS EMPTY! CANNOT COPY!
The P2 card whose data is to be copied is blank.
A blank card does not need to have its data
copied so no data is copied.
VERIFICATION FAILED!
A mismatch was found by verification after
copying. Copy the data again.
TURN POWER OFF!
Turn the power off, and turn it back on for use.
CANNOT RECOGNIZE HDD!
The connection destination target cannot be
recognized correctly. Turn the power of the
hard drive off and then back on or change the
connected hard drive.
PLEASE FORMAT P2 CARD!
This message warns the user that data cannot
be copied when data is imported from a hard
drive to a P2 card because the P2 card already
has data recorded on it. No data can be copied
because the copy destination P2 card is not a
blank card. After formatting the card using the P2
device, initiate copying again.
