26
P2 cards (continued)
Ejecting P2 cards
1
Press .
When the P2 card access LED to be ejected is
blinking in orange, press to stop it blinking.
2
Open the card slot cover, push the card
eject button once, and when the button
pops out, push the button again.
3
After ejecting the P2 card, close the card
slot cover.
• Do not eject cards or turn off the power in the
following situations: otherwise, this may cause
P2 card trouble.
a
While the orange P2 card access LED device
is changing from blinking to lighting after the
P2 card has been inserted
b
During recording, during the process to
complete recording or while the P2 card
access LED is blinking
• In the event that a P2 card being formatted or
accessed has been ejected, “TURN POWER
OFF” is displayed on the LCD monitor. In a case
like this, turn the power off and then turn it back
on.
When a card was ejected while it was being
formatted:
Re-format the card.
When a card was ejected while its data was
being accessed:
Something may have gone wrong with one of the
clips (Page 30). Check the clips, and repair the
abnormal one. (For details on repairing clips
→
1
2
• During playback, a P2 card will not be recognized
even if it has been inserted into the other empty
slot, and the P2 card access LED will not
light. After playback is completed, the P2 card
recognition process is started.
• If the P2 card is ejected while thumbnails are
displayed, the thumbnail display screen will be
cleared.
Precaution for using P2 cards
P2 cards must always be formatted using a P2
device prior to use.
Card eject button
