Recor
ding Features
-English-
21
Recording Features
5
Press +/–
to select
AV JACK
, then
press SET
to select IN.
6
Press +/–
to select
AUDIO SEL
, and
then
press SET
to select LINE.
7
Press +/–
to select
AUDIO DUB
, and
then
press SET
to select ON.
• This unit will go to Stand By mode,
and “A.DUB ” indication appears in
the LCD monitor.
• “LINE A IN” (LINE) or “MIC IN” (MIC)
will appear in the LCD monitor. (p. 32)
8
Press (PAUSE)
to start Audio
Dubbing.
Only PAL (Phase Line alternation) recorded
tapes can be audio dubbed. The following
screen appears if the tape was not
recorded in PAL format.
9
Press (PAUSE)
to stop Audio
Dubbing.
To listen to the desired audio sound, set the
AUDIO setting of the PLAYBACK MODE
menu (Menu OSD: p. 29) as follows:
• If the microphone used gets too near the
speaker on your TV or on this unit, a
howling noise (feedback) may occur. In
this case, either move the mic farther
away or turn the volume down. (p. 14)
• If the tape position is in or was started in a
blank section, you cannot use the A.DUB
feature.
• When a 16 bit recording is dubbed over,
the original audio of the recording will be
erased.
• When a 12 bit recording is dubbed over
and played back, and MIX is selected as
the AUDIO, both the original audio and
the dubbed audio are played back.
• If you recorded in LP mode, you cannot
use the A.DUB feature.
Note
ST 1
ST 2
MIX
Set this position to listen to the
original sound.
Set this position to listen to the
audio dubbed sound.
Set this position to listen to both
the original sound and the audio
dubbed sound.
AUDIO:
The following selections are
available for 12 bit AUDIO dubbed
recordings only (sound recorded in SP
mode only).
8, 9
PAUSE
5
,
6
, 7
+/– (SELECT)
5
,
6
, 7
SET
When using an External Recording Source
Audio Out
To Audio Out
A/V Cable (Supplied)
A/V IN
Follow the steps
1
~
4
on page 20.
DV1DC.Eng19-21.p65
2003/02/28, 17:02
21