START-UP AFTER INSTALLATION
Once you have assembled and installed all the
components, turn on the water supply first tocheck
for leaks.Then, turn on the faucet slowly. At the first
stage, water will run from the faucet slowly. Let it
run in this way for 10 minutes. If the waterstarts to
drip and do not reach normal flowrate, it probably
means that the water pressure isso low that the
device cannot perform with 100 % efficiency. If you
are experiencing such a problem, see Troublesho-
oting on page 17.
Now your device is ready for usage, you can enjoy
quality water safely.
!! IMPORTANT !!
*During the first few days after installation, air bubbles
may be seen in the water.
*Water treatment device will work better and longer when
it is used more often. For this reason, we recommend you
use the purified water for cooking, preparing tea, coffee etc.
*In case of water leaks, broken filters etc., turn off the valve
of water supply and correct the faults.
REPLACEMENT PERIODS OF CARTRIDGE FILTERS
If feeding tube is damaged, it should be replaced
with a specially prepared tube or tube set supplied
by the manufacturer or authorised service.
12” 5 Micron Spun (Sediment) Filter:
It should be replaced approximately every 6
months depending on the water contamination.
12” GAC Carbon Cartridge Filter (UDF):
If the water is clear and the total amount of
chlorine is low, the cartridge life is 6 months on
average.
12” Block Carbon Cartridge Filtre (CTO):
The cartridge life is approximately 6 months
depending on the amount of chlorine in the water
and replecament periods of pre-filters.
Membrane Filter:
The membrane life is approximately 3 years
depending on the regular maintenance.
10” Inline Coconut Post Carbon Filter:
The cartridge life is approximately 12 months.
USERS MANUAL |
11
MAINTENANCE AND CLEANING
