ILF 33/44/55 Installation Manual
Rev 1.1
54
13
Final Inspection Check List
Liftgate failure or malfunction could result in property damage, personal injury or death if you fail to
check each of the following items listed. DO NOT USE the liftgate if any of the following points are
NOT verified and checked.
Installation is NOT complete and all WARRANTIES are VOID if you have not checked and verified all
items listed on this inspection sheet. Inspection sheet is to be filed at the facility where liftgate was
installed.
Structural Inspection
All welds are 100% complete per this manual.
All nuts, bolts, mounting hardware, pins, chain anchors are tight.
All mounting dimensions are correct and liftgate is square and parallel per this manual.
Capped frame cutout with flat bar or angle.
Hydraulic Inspection
Pump reservoir is filled to 1.5" from top when cylinders are completly compressed (platform is resting on the ground).
Hydraulic components and connections do not leak.
(Should be checked after unit is hydraulically locked for five (5) minutes.)
All hydraulic lines are secured with cable ties, hoses clamps, or other fasteners. No hoses or components rub on the
frame, platform, or any other components while unit is in operation or in storage. No hoses are kinked or bent.
Electrical Inspection
Battery cable(s) attached and clamped tight and dielectric grease is used to seal all connections.
All electrical lines are secured with cable ties, hoses clamps, or other fasteners and are properly protected.
Circuit Breakers installed and wired per instructions.
Lights wired properly and operate per DOT, State, and Federal requirements.
All connectors at the control board are properly connected to their corresponding ports.
Measured battery voltages: Flooded Batteries = 12.6V; AGM Batteries = 12.8V.
Operational Inspection
All decals are in place and legible per instructions.
All pivot points are lubricated per instructions, and Zerk fittings have been capped.
Up stops are in place. Wheel is set for proper opening when lowering. Snubber pads are tight against platform.
Platform travels up and down smoothly and freely, without any hesitation or unusual noises.
Platform
is flush with the bed extension, tip is pitched approximately 2“-2.5“ above rear bed extension when raised
completely.
Platform rests on the ground when tilted via the operational control.
Platform raises and lowers properly and at correct speed. (2 to 4 inches per second)
Gate is painted, body is clean around gate. Cylinders are clean and rubber & plastic caps are in place.
The liftgate serial number and model number are documented on the inside of the front cover of the Owners Manual,
as well as the installation manual in the space provided.
Owners Manual is in the vehicle's glove box.
Supervisor has demonstrated the instructions in the Owners Manual to the customer/driver upon delivery.
Inspection Information:
Name (please print): ____________________________________________________________
Completed by: _________________________________________________________________
(Signature)
Title: ______________________________________________ Date: ______________________.
