40/172
cod. 00 477 2250 - 11/2013 - PN - Italy
INTRODUCTION
2 SAFETY WARNINGS
2.1 INSTALLATION
WARNINGS
manual.
The stove assembly and dismantling instructions
are reserved exclusively for specialist technicians.
Users should always contact our service centre
to request work to be performed by qualified
technicians. Before having work performed by other
technical personnel verify their effective technical
competence.
Responsibility for work carried out in the place
where the stove is installed lies with the user;
the user is also responsible for making sure the
installation checks are completed.
The user must abide by all local, national and
European safety requirements.
' w
suitable load-bearing capacity.
Make sure that the flue and air intake duct
arrangements correspond to the type of installation.
Do not make any electrical connections using
temporary or uninsulated cables.
Make sure the electrical system is earthed correctly.
Before starting to assemble or dismantle the stove,
the installer must heed the safety precautions
A) do not work in adverse conditions;
? _
and make sure that personal protective equipment
is in perfect working order;
C) always wear safety gloves;
D) always wear safety shoes;
E) always use electrically insulated tools;
F) make sure that the area being used for assembly
and dismantling is clear of any obstacles.
2.2 MAINTENANCE
WARNINGS
this manual.
@
other means of protection.
?
that the stove, if it had been operating, has cooled
down.
*
calibrated or not working, the stove must be
considered out-of-service.
electronic parts and connectors.
2.3 WARNINGS FOR THE USER
"
with local, national and European regulations.
#
hot outside surfaces. For this reason maximum
to avoid getting burned;
w
!
manual.
}
!
'
must always be perfectly legible. If damaged or
illegible they must be replaced, contacting the
manufacturer for an original spare label.
W
shown in the corresponding chapter of this
manual.
Y
maintenance plan.
the chapter on “Maintenance” in this manual.
suspected breakage or unusual noises.
w
pot.
power cord.
this may affect stability.
or anchor.
ash have completely cooled down.
'
down.
"
way as to ensure maximum safety.
*
off using the procedure described in par. 9.3.
*w
w
procedure described in par. 15.4.
'
paragraph 15.4.
to avoid damaging the paintwork.
